Engineering Graphics & Design (3110013) MCQs

MCQs of Introduction to Engineering Graphics (SP-46)

Showing 1 to 10 out of 117 Questions
1.
The preferred size of the drawing sheets is recommended by the ______
(a) B.I.S.
(b) ASME
(c) ASTM
(d) NIST
Answer:

Option (a)

2.
The untrimmed size for _______ sheet is 240 mm x 330 mm.
(a) A1
(b) A2
(c) A3
(d) A4
Answer:

Option (d)

3.
SP: 46 (2003) recommends the borders of _______ mm width for the sheet sizes A0 and A1, and _______ mm for the sizes A2, A3, A4 and A5.
(a) 10, 20
(b) 15, 20
(c) 20, 10
(d) 15, 10
Answer:

Option (c)

4.
The size of the title block is ________ mm x ________ mm.
(a) 25 x 10
(b) 100 x 25
(c) 60 x 185
(d) 185 x 65
Answer:

Option (d)

5.
__________ is not an essential thing for free-hand sketching.
(a) A soft-grade pencil
(b) French curves
(c) A soft rubber-eraser
(d) A paper in the form of a sketch-book or a pad
Answer:

Option (b)

6.
How many battens will be there for a Drawing board?
(a) 1
(b) 2
(c) 3
(d) 4
Answer:

Option (b)

7.
The angle which we can’t make using a single Set-square is ________
(a) 45 Degree
(b) 30 Degree
(c) 60 Degree
(d) 75 Degree
Answer:

Option (d)

8.
The angle which we can’t make using both the Set-squares is _____________
(a) 15 Degree
(b) 105 Degree
(c) 165 Degree
(d) 125 Degree
Answer:

Option (b)

9.
Which is not the use of divider?
(a) To divide curved or straight lines into the desired number of equal parts
(b) To draw circles
(c) To transfer dimensions from one part of the drawing to another part
(d) To set-off given distances from the scale to the drawing
Answer:

Option (b)

10.
_________ is used to draw curves which are not circular.
(a) Compass
(b) Protractor
(c) French curves
(d) Pro circle
Answer:

Option (c)

Showing 1 to 10 out of 117 Questions