A transmission and distribution engineer needed to design the sub transmission substation. The tapping component needed is

While designing the distribution to locality of one lac population with medium dense load requirement, system employed is

A _________ distribution system is more reliable than the ______ distribution system.

A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‘a’ and resistance ‘R₁’. If the DC tow wire replaces the system, then the ratio of volume of each conductor V₁/V₂

While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.

A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‘a’ and resistance ‘R1’. If this is replaced by monopolar system, then saving of copper is

For the single phase 2-wire system, the maximum voltage between the outer wires and earth is

For a 440V distribution system the maximum voltage at the midpoint

If a 2-wire ac single phase distribution system operating at ‘P’ MW and ‘V’ kV, operating at the power factor of 0.8, then the current in the outer wire in kA is

If a 2-wire ac single phase distribution system operating at ‘30’ MW and ‘315’ kV, operating at the power factor of 0.8, then the current in the outer wire in kA is