Design of Steel Structures (2180610) MCQs

MCQs of Connections

Showing 31 to 40 out of 50 Questions
1 2 3 4 5
31.
Clip and seating angle connection is provided for
(a) Lateral support
(b) Bending support
(c) Frictional support
(d) Hinged support
Answer:

Option (a)

32.
Moment Resistant Connections transfer (i) Moments, (ii)Axial force, (iii)shear force
(a) i only
(b) i and ii
(c) ii and iii
(d) i, ii and iii
Answer:

Option (d)

33.
The effect of twisting moment and shear force on the bolt group cause ____ whereas bending moment and shear force cause ________
(a) Shear force on the bolts, tension and shear in the bolt
(b) Tension and shear in the bolt, shear force on the bolts
(c) Shear force on the bolts, shear force on the bolts
(d) Tension and shear in the bolt, tension and shear in the bolt
Answer:

Option (a)

34.
Clip angle connection are designed to
(a) Transfer small end moments in addition to large end shear
(b) Transfer large end shear only
(c) Transfer small end moments only
(d) Transfer bending moments
Answer:

Option (a)

35.
Which of the following is true about bracket connections?
(a) More rigid than any other connection.
(b) Fabrication cost is low.
(c) These connections are used to accommodate less number of bolts.
(d) They are used to give aesthetic appearance to the structure.
Answer:

Option (a)

36.
In bolted moment end plate connection, bending moment , axial force and shear force are transferred by
(a) Tension only
(b) Compression only
(c) Tension and compression
(d) Friction
Answer:

Option (c)

37.
Which of the following connections can be used for beam-beam connection?
(a) Pin Connection
(b) Moment Resistant Connection
(c) Simple Connection
(d) Complex Connection
Answer:

Option (c)

38.
In practice, secondary beams are connected to main beams by ______
(a) Web cleats
(b) Bolts
(c) Seating angle
(d) Web cleats and bolts
Answer:

Option (a)

39.
When cantilever beam is supported by girder, the end of cantilever will transfer
(a) Shear force
(b) Torsion
(c) Bending moment
(d) Shear force and Bending moment
Answer:

Option (d)

40.
Which of the following type of weld is most suitable for lap and T-joints?
(a) Fillet weld
(b) Groove weld
(c) Slot weld
(d) Plug weld
Answer:

Option (a)

Showing 31 to 40 out of 50 Questions
1 2 3 4 5