Engineering Graphics & Design (3110013) MCQs

MCQs of Introduction to Engineering Graphics (SP-46)

Showing 101 to 110 out of 117 Questions
7 8 9 10 11 12
101.

The following is not included in title block of drawing sheet.

(a)

Sheet No
(b)

Scale
(c)

Method of Projection
(d)

Size of sheet
Answer:

Option (d)

102.

In first angle projection method, object is assumed to be placed in

(a)

First quadrant
(b)

Second quadrant
(c)

Third Quadrant
(d)

Fourth quadrant
Answer:

Option (a)

103.

The following line is used for visible outlines

(a)

Continuous thick
(b)

Continuous thin
(c)

Chain thin line
(d)

Short zigzag thin
Answer:

Option (a)

104.

The following line is used for dimension line

(a)

Continuous thick
(b)

Continuous thin
(c)

Chain thin line
(d)

Short zigzag thin
Answer:

Option (b)

105.

The dotted lines represents

(a)

Hidden edges
(b)

Projection line
(c)

Centre line
(d)

Hatching line
Answer:

Option (a)

106.

Hatching lines are drawn at ___ degree to reference line

(a)

30
(b)

45
(c)

60
(d)

90
Answer:

Option (b)

107.

In aligned system of dimensioning, the dimensions may be read from

(a)

Bottom or right hand edges
(b)

Bottom or left hand edges
(c)

Only from bottom
(d)

Only from left side
Answer:

Option (a)

108.

Representative fraction’ (RF) is defined as

(a)

Length of an object in the drawing / Actual length of the object
(b)

Length of an object in the drawing / Isometric length of the object
(c)

Actual length of the object / Length of an object in the drawing
(d)

Isometric length of the object / Length of an object in the drawing
Answer:

Option (a)

109.

A line of 1 meter is shown by 1cm on a scale. Its Representative fraction (RF) is

(a)

1
(b)

100
(c)

1/100
(d)

1/50
Answer:

Option (c)

110.

The first step in creating a traditional technical drawing is to ________.

(a)

Draw a series of guide lines
(b)

Set up the meter line
(c)

Align the paper so that it will be positioned square to the parallel bar
(d)

Sharpen the leads in the technical pens
Answer:

Option (c)

Showing 101 to 110 out of 117 Questions
7 8 9 10 11 12