Engineering Graphics & Design (3110013) MCQs

MCQs of Introduction to Engineering Graphics (SP-46)

Showing 41 to 50 out of 117 Questions
2 3 4 5 6 7
41.
Which are the two systems of placing dimensions? i. The aligned system, ii. Break system, iii. The unidirectional system, iv. Directional system
(a) i, ii
(b) i, iii
(c) ii, iv
(d) i, iv
Answer:

Option (b)

42.
The aligned system is used for drawing of air crafts, automobiles.
(a) True
(b) False
Answer:

Option (b)

43.
In unidirectional system the dimensions are ______
(a) Placed above the dimension lines
(b) Placed below the dimension lines
(c) Placed by breaking the dimension line in the middle
(d) Placed left side of the dimension line
Answer:

Option (c)

44.
In aligned system the dimensions are __________
(a) Placed parallel to the dimension line
(b) Placed perpendicular to the dimension line
(c) Placed left side of the dimension line
(d) The placed right side of the dimension line
Answer:

Option (b)

45.
From unidirectional system, it is __________
(a) Convenient to read dimensions from the bottom edge
(b) Convenient to read dimensions from the right-hand edge
(c) Convenient to read dimensions from the right-hand edge
(d) Convenient to read dimensions from the top edge
Answer:

Option (a)

46.
In which system of dimensioning the figures can read from the bottom as well as right-hand side of the drawing?
(a) Aligned system
(b) Unidirectional system
(c) Nonaligned multidirectional system
(d) Parallel system
Answer:

Option (a)

47.
In dimensioning, the lines enclosing the dimension line are known as ____
(a) Leader line
(b) Dimension line
(c) Extension line
(d) Outline
Answer:

Option (c)

48.
When dimensioning the circle, the dimension line begins from the center of the circle.
(a) True
(b) False
Answer:

Option (a)

49.
While dimensioning holes, slots, etc. how would their number be specified?
(a) The number is written on the dimension line
(b) The number is written of the leader line
(c) The number is written on the corner of the page
(d) The number is written on the side of the hole or slot
Answer:

Option (a)

50.
In a unidirectional system, the figures are written along the dimension line.
(a) True
(b) False
Answer:

Option (b)

Showing 41 to 50 out of 117 Questions
2 3 4 5 6 7