MCQs of Basic Machine Tools and Metal Cutting Principles (Manufacturing Processes - 3141908)

Showing 61 to 70 out of 100 Questions

61.

Machine tools must be tough enough to withstand_____

62.

Carbides are used in_____

(a)	rapid stock removal
(b)	higher speeds
(c)	rapid stock removal and higher speed both
(d)	none of the mentioned

63.

“Light finishing cuts inexpensive forming tools”- this quality is applicable to_____

64.

Which of the following is easy to grind and generally used for intermittent cut?

65.

High speed steel has an excessive wear on______

(a)	castings
(b)	hard materials
(c)	casting and hard materials both
(d)	none of the mentioned

66.

High-speed steel has an excessive wear on______

(a)	castings
(b)	hard materials
(c)	casting and hard materials both
(d)	none of the mentioned

67.

Which of the following is not the disadvantage of diamonds?

(a)	incompressible
(b)	readily conducts heat
(c)	the rigid machine is required
(d)	all of the mentioned

68.

Which of the following tool material is not suitable for small diameters?

69.

Small nose radius

(a)	increases tool life
(b)	decreases tool life
(c)	produces chipping and decreases tool life
(d)	results in excessive stress concentration and greater heat generation

70.

The lip angle is the angle

(a)	between the tool face and the ground end surface of the flank
(b)	made by the face of the tool and the plane parallel to the base of the cutting tool
(c)	between the face of the tool and a line tangent to the machined surface at the cutting point
(d)	none of the above

Showing 61 to 70 out of 100 Questions