Manufacturing Processes (3141908) MCQs

MCQs of Planers, Shapers and Slotters

Showing 1 to 10 out of 16 Questions
1.
The top and sides of the table of a shaper usually have
(a) L-type slots
(b) T-type slots
(c) I-type slots
(d) any one of these
Answer:

Option (b)

2.
In a shaper, the length of stroke is increased by
(a) increasing the center distance of bull gear and crank pin
(b) decreasing the center distance of bull gear and crank pin
(c) increasing the length of the arm
(d) decreasing the length of the slot in the slotted lever
Answer:

Option (a)

3.
The type of tool used on lathe, shaper, and planer is
(a) single-point cutting tool
(b) two-point cutting tool
(c) three-point cutting tool
(d) multi-point cutting tool
Answer:

Option (a)

4.
The size of a shaper is given by
(a) stroke length
(b) motor power
(c) mass of machine
(d) rate size
Answer:

Option (a)

5.
In a planer
(a) the tool is stationary and work reciprocates
(b) work is stationary and tool reciprocates
(c) the tool moves over stationary work
(d) the tool moves over reciprocating work
Answer:

Option (a)

6.
In a shaper, the metal is removed during
(a) forward stroke
(b) return stroke
(c) both the forward and return strokes
(d) neither the forward nor the return stroke
Answer:

Option (a)

7.
In a shaper
(a) the tool is stationary and work reciprocates
(b) work is stationary and tool reciprocates
(c) the tool moves over stationary work
(d) the tool moves over reciprocating work
Answer:

Option (b)

8.
The operation performed on a shaper is
(a) machining horizontal surface
(b) machining vertical surface
(c) machining angular surface
(d) all of these
Answer:

Option (d)

9.
The operation performed on a shaper is
(a) machining horizontal surface
(b) machining vertical surface
(c) machining angular surface
(d) all of these
Answer:

Option (d)

10.
Which of the following act as housing for an operating mechanism in the shaper?
(a) Base
(b) Column
(c) Cross rail
(d) Table
Answer:

Option (b)

Showing 1 to 10 out of 16 Questions