Engineering Graphics & Design (3110013) MCQs

MCQs of Introduction to Engineering Graphics (SP-46)

Showing 111 to 117 out of 117 Questions
7 8 9 10 11 12
111.

The primary unit of measurement for engineering drawings and design in the mechanical industries is the:

(a)

Millimeter
(b)

Centimeter
(c)

Meter
(d)

Kilometer
Answer:

Option (a)

112.

The most common geometric form used in gears today is this:

(a)

Involute profile
(b)

Convolute profile
(c)

Base circle
(d)

Spur circle
Answer:

Option (a)

113.

The locus of a point P about another point O such that its distance from O is constant is ________

(a)

 a line passing through O
(b)

two parallel lines equidistant from O
(c)

a circle with center O
(d)

a curve with O in it
Answer:

Option (c)

114.

The locus of a point P such that its distance from a fixed line AB is constant is____________

(a)

a circle with AB as the largest chord (diameter)
(b)

a line perpendicular to AB passing through the midpoint of AB
(c)

a line parallel to AB
(d)

a line perpendicular to AB cutting AB at center
Answer:

Option (c)

115.

Locus of a point P equidistant from two fixed points A and B is ____________

(a)

an ellipse
(b)

a line perpendicular to AB passing through the midpoint of AB
(c)

a circle with AB as largest chord
(d)

 a parallel line of AB
Answer:

Option (b)

116.

The locus of point which is equidistant from 2 non parallel lines is ___________

(a)

a straight line bisecting the angle between them
(b)

a line which cuts both lines at same distances from point of intersection of given lines
(c)

 a closed curve around them
(d)

a line perpendicular to the 1st line
Answer:

Option (a)

117.

Locus of a point P equidistant from a fixed line and fixed point F is _____________

(a)

a circle with center F
(b)

an ellipse with foci P and F
(c)

a parabola
(d)

a hyperbola
Answer:

Option (c)

Showing 111 to 117 out of 117 Questions
7 8 9 10 11 12