Engineering Graphics & Design (3110013) MCQs

MCQs of Introduction to Engineering Graphics (SP-46)

Showing 11 to 20 out of 117 Questions
1 2 3 4 5 6
11.
The areas of the two subsequent sizes of drawing sheet are in the ratio ____
(a) 1:5
(b) 1:4
(c) 1:2
(d) 1:10
Answer:

Option (c)

12.
The sizes from A0 to A5 increases.
(a) True
(b) False
Answer:

Option (b)

13.
The increase in hardness is shown by the value of the figure put in front of the letter H, 2H, 3H, and 4H etc.
(a) True
(b) False
Answer:

Option (a)

14.
The Grade becomes ______ according to the figure placed in front of the letter B, 2B, 3B, 4B, etc.
(a) harder
(b) lighter
(c) darker
(d) softer
Answer:

Option (d)

15.
Which of the following instrument is made of thin strips of wood arranged in a line to form a rectangle and on which, the drawing is made?
(a) Mini – drafter
(b) Drawing Board
(c) Protractor
(d) Scale
Answer:

Option (b)

16.
Which of the following tools is used to draw horizontal lines?
(a) Mini – drafter
(b) Protractor
(c) T – square
(d) French curve
Answer:

Option (c)

17.
Which of the following instrument can be used to draw accurate perpendicular lines, parallel lines, and angular lines?
(a) Mini – drafter
(b) T – square
(c) Protractor
(d) Set square
Answer:

Option (a)

18.
Which is the most common tool used for drawing circles?
(a) French curve
(b) Mini – drafter
(c) Divider
(d) Compass
Answer:

Option (d)

19.
For drawing circles with a large radius, which of the following tool is used?
(a) Bow compass
(b) Lengthening bar compass
(c) Divider
(d) Protractors
Answer:

Option (b)

20.
Which of the following drawing tools is used by architects for making blueprints?
(a) Drawing Pencils
(b) Dusters
(c) Ink Pen
(d) Erasers
Answer:

Option (c)

Showing 11 to 20 out of 117 Questions
1 2 3 4 5 6